Vauxhall Zafira 2014 Owner's Manual Page 182

  • Download
  • Add to my manuals
  • Print
  • Page
    / 217
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 181
Vehicle care 181
9. Switch on the compressor by
pressing the on/off switch. The
tyre is filled with sealant.
10. The compressor pressure gauge
briefly indicates up to 6 bar whilst
the sealant bottle is emptying
(approx. 30 seconds). Then the
pressure starts to drop.
11. All of the sealant is pumped into
the tyre. Then the tyre is inflated.
12. The prescribed tyre pressure
should be obtained within
10 minutes. Tyre pressure
3 207. When the correct pressure
is obtained, switch off the
compressor by pressing the on/off
switch again.
If the prescribed tyre pressure is
not obtained within 10 minutes,
remove the tyre repair kit. Move
the vehicle one tyre rotation.
Reattach the tyre repair kit and
continue the filling procedure for
10 minutes. If the prescribed tyre
pressure is still not obtained, the
tyre is too badly damaged. Seek
the assistance of a workshop.
Release excess tyre pressure
using the ] button.
Do not run the compressor longer
than 10 minutes.
13. Disconnect plug from power
outlet, place in plug compartment
and remove tyre repair kit. Push
catch on bracket to remove
sealant bottle from bracket. Screw
tyre inflation hose to the free
connection of sealant bottle. This
prevents sealant from escaping.
Stow tyre repair kit in load
compartment.
14. Remove any excess sealant
using a cloth.
15. Take the label indicating
maximum permitted speed from
the sealant bottle and affix in the
driver's field of view.
16. Continue driving immediately so
that sealant is evenly distributed
in the tyre. After driving approx.
6 miles (but no more than
10 minutes), stop and check tyre
pressure. Screw compressor air
hose directly onto tyre valve and
compressor when doing this.
If tyre pressure is more than
1.3 bar, set it to the correct value.
Repeat the procedure until there
is no more loss of pressure.
If the tyre pressure has fallen
below 1.3 bar, the vehicle must
not be used. Seek the assistance
of a workshop.
17. Stow away tyre repair kit in load
compartment.
Note
The driving characteristics of the
repaired tyre is severely affected,
therefore have this tyre replaced.
If unusual noise is heard or the
compressor becomes hot, turn
compressor off for at least 30
minutes.
The built-in safety valve opens at a
pressure of 7 bar.
Note the expiry date of the kit. After
this date its sealing capability is no
longer guaranteed. Pay attention to
storage information on sealant
bottle.
Page view 181
1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 216 217

Comments to this Manuals

No comments