Vauxhall Ampera Owner's Manual Page 160

  • Download
  • Add to my manuals
  • Print
  • Page
    / 195
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 159
Vehicle care 159
If the tyre pressure shall be reduced,
switch off ignition before reducing.
Sensor matching process -
Manual
Each tyre pressure monitoring
system sensor has a unique
identification code. The identification
code needs to be matched to a new
tyre/wheel position after rotating the
vehicle’s tyres or replacing one or
more of the sensors. Also, the tyre
pressure monitoring system sensor
matching process should be
performed after replacing a spare tyre
with a road tyre containing the tyre
pressure monitoring system sensor.
A and the DIC message should go off
at the next drive cycle. The sensors
are matched to the tyre/wheel
positions, using a tyre pressure
monitoring system relearn tool, in the
following order: left front tyre, right
front tyre, right rear tyre and left rear
tyre. Ask your Authorised Vauxhall
Ampera Repairer for service or to
purchase a relearn tool.
There are two minutes to match the
first tyre/wheel position and
five minutes overall to match all four
tyre/wheel positions. If it takes longer,
the matching process stops and must
be restarted.
Follow the tyre pressure monitoring
system sensor matching process:
1. Set the parking brake.
2. Switch the ignition on and place
the vehicle in P.
3. If the DIC display is minimised,
press the SELECT knob to
maximise it.
4. Use the SELECT knob to scroll to
the tyre pressure display screen.
5. Press and hold the SELECT knob
for five seconds to begin the
sensor matching process.
A message displays confirming to
begin the process.
6. Use the SELECT knob to select
YES with the highlighted selection
and press the SELECT knob
again to confirm the selection.
The horn sounds twice to signal
the receiver is in relearn mode
and a message displays on the
DIC screen.
7. Start with the left front tyre.
8. Place the relearn tool against the
tyre sidewall, near the valve stem.
Then press the button to activate
the tyre pressure monitoring
system sensor.
A horn chirp confirms that the
sensor identification code has
been matched to this tyre and
wheel position.
9. Proceed to the right front tyre and
repeat the procedure in Step 8.
Page view 159
1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 194 195

Comments to this Manuals

No comments